Interquartz IQ750 - Manual (Page 23)

23
Direct Access Memory Capacity
Each memory can store up to 32 digits plus Pause, , Recall (Flash) and a Handsfree
code.
Speed-Dialling (Storable Handsfree code)
When storing a number, you can add a “Handsfree” command to the start of the number.
It appears as an “H” on-screen. This programming technique makes dialling faster and
easier – to commence dialling of any Direct Access memory programmed with a “Handsfree”
code the memory key can be pressed without the need to lift the handset or press the
Handsfree/Headset key.
Speed-Dialling and Automatic Hang-up
The Handsfree code may also be stored in a Direct Access memory key at the trailing
end of a stored number to make the telephone hang up immediately after dialling the
number.
Example (where “H” represents the Handsfree code and “nnnnn” represents any subsequent
digits to be dialled)
1. If H is entered as a prefix code:
Stored string: H nnnn
Result: The phone will go on-line in Handsfree mode and dial out the subsequent
number. Phone will remain on-line in handsfree mode until the user manually
hangs up.
2. If H is entered at both ends of the digits to be dialled
Stored string: H nnnnn H
Result: The phone will go on-line in Handsfree, dial out the number and go off line
again.
To store a Number and Name in a Direct Access memory
1. Press STORE; the display will show “STORE”
2. Press the Memory Key either once to store in a One-Touch memory or twice for a
Two-Touch memory; the display will show “ENTER NUMBER”
3. If you wish to setup the chosen memory key as a speed-dial key, go to step 4.
Otherwise go to step 5