Interquartz IQ750 - Manual (Page 37)

37
If two Pauses (i.e. 200 mSec) do not produce a long enough post-Recall pause for the
network switch, try three pauses (300mSec) or four (400mSec) or more.
The Pause time setting remains set until the user changes it - removal of power sources
or line connection will not change the setting.
HOLDING AND TRANSFERRING CALLS
The method used for these functions is dependent on your system type, so you will need
to check your system’s Extension User Guide. The RECALL Key is typically used to
transfer calls and the Recall Timing setting affects the Recall Key’s ability to function
correctly with your system (see below).
USING THE MEMORIES
Any combination of numbers, and , Pause, Recall and Handsfree commands can
be stored. You may find it useful to store some of your favourite network facility commands
in the telephone for fast, convenient access to those facilities (e.g. Diversion, Call Forward,
Call Back etc). Consult your system User Guide for the codes that you need to store.
The Direct Access Memories can be pre-programmed at point of sale with network feature
codes. For further information, please refer to the “Memory Operation” and “Memory
Protection Switch” sections of this manual.
Speed Dialing
When storing a number, you can add a “Speed Dialing” command to the start of the
number. This makes dialling faster and easier. The “H” command, entered by pressing
the HANDSFREE/HEADSET preceding the telephone number in the Memory Storage
procedure, activates the Handsfree function during dialing so that you can make a Handsfree
call just by pressing the memory key once it is programmed.
Cascade Memory Dialing
The contents of more than one memory can be “cascaded” or added together during a
call to create a long dialling sequence by pressing the required memory keys in the
desired order. This feature can be used to store unusually long numbers, which may
exceed the digit capacity of any individual memory.