Interquartz IQ750 - Manual (Page 24)

24
4. Press HANDSFREE/HEADSET; the DISPLAY will show “H” in the number field. If
this is not required, go to step 5 without pressing HANDSFREE/HEADSET
5. Enter the telephone number and press STORE
6. Enter the name by using the Keypad and press STORE to confirm; the display will
show “MEMORY STORED”.
To dial from a Direct Access Memory
Speed-Dial memory (i.e. the memory key has been programmed with an “H” preceding
the number as described above):
Press the desired Memory Key either once to dial from its One-Touch memory or twice
to dial from its Two-Touch memory.
Non Speed-Dial memory (i.e. the memory key has NOT been programmed with an “H”
preceding the number as described above):
Press the desired Memory Key either once to dial from its One-Touch memory or twice
to dial from its Two-Touch memory.
Direct Access Memories and the Memory Protection Switch
The Memory Protection Switch protects the upper row of five memory keys near the
display to prevent them from being overwritten by the user in daily use. The memory
protect switch is located underneath the lower memory number card (see Figure 4).
it is recommended that the upper row of 5 memory keys (i.e. 10 Direct Access Memories)
be programmed to create network features access keys to store some of your favourite
network facility codes (e.g. Diversion, Call Forward, Call Back etc). This will enable more
convenient access to these features without the need to remember the necessary codes.
The memory card paper insert below the memory keys can be used to label the keys to
indicate their new functions (i.e. the name of the network feature). Consult your system
User Guide for the codes that you need to store.
If your upper-row memory keys are locked and prevent storage of new numbers this may
be due to the presence of pre-programmed codes chosen by your system administrator.
Before moving the switch to the “Non-Protected” position we recommend that you contact
your system administrator, Interquartz or your dealer to discuss if they can be unlocked.
Changing the switch setting may allow any pre-programming to be lost.