Integra DTR-7 - Manual (Page 22)

22
Setting the bass peak level
(Bass Peak Level Manager
* DTR-7 only)
To prevent damage to your subwoofer, you can set the bass peak
level the subwoofer can reproduce.
If your system does not include any subwoofer, this will set the bass
peak level your Front speakers can reproduce.
1. Press the SP/SYS SETUP button repeatedly until
“Bass Peak Setup?” appears. Then Press the SMART SCAN
CONTROLLER.
“Limiter =”appears and you are now in the bass peak level set-
ting mode.
2. Rotate the SMART SCAN CONTROLLER to select “Yes”
or “No.”
If you select “Yes” and then press the SMART SCAN CON-
TROLLER, the display will show the current peak level fol-
lowed by “Test Tone ON?.”
3. Press the SMART SCAN CONTROLLER.
The test tone is output and “Turn SSC Up” appears.
4. Gently rotate the SMART SCAN CONTROLLER clockwise
and, just before sound is distorted, press the SMART SCAN
CONTROLLER.
If you do not press the SMART SCAN CONTROLLER, “Dis-
torts Push SSC” appears.
Note:
• Allowing the speakers to produce distorted sound for a long
time may cause damage to the speakers.
• To disable the bass peak level limiter, select “No” in step 2.
Setting the Speaker level
1
2
3
4
SP/SYS
SETUP
PRESET/MODE ADJ
PUSH TO ENTER
PRESET/MODE ADJ
PUSH TO ENTER
PRESET/MODE ADJ
PUSH TO ENTER
PRESET/MODE ADJ
PUSH TO ENTER
PRESET/MODE ADJ
PUSH TO ENTER
SPEAKERS
A
DSP
SPEAKERS
A
SPEAKERS
A
SPEAKERS
A
SPEAKERS
A
SPEAKERS
A
db
SPEAKERS
A
db
PRESET/MODE ADJ
PUSH TO ENTER
* Bass Peak Level Manager is a registered trademark of Lucasfilm LTD.