Setting the listening mode parameters, How to set the listening mode parameters – Integra DTR-7 User Manual
Page 38
38
Parameter
Re-EQ*
LateNight*
LFE level* Front Effect* Reflect Level*
Reverb Level
Room Size
Listening mode
Stereo(3 Stereo)
*
Dolby Pro Logic
*
O
THX Cinema
O
Action/Musical
O
O
O
O
O
Mono Movie
O
O
O
O
O
Orchestra/Unplugged/
*
O
O
O
O
O
Studio-Mix/TV Logic
5ch Stereo
*
Direct
*
Dolby Digital
*
O
O
O
THX Cinema
O
O
O
Action/Musical
O
O
O
O
O
O
O
Mono Movie/Orchestra/
Unplugged/Studio-Mix/
O
O
O
O
O
O
O
TV Logic
Dolby Digital Pro Logic
*
O
O
O
Action/Musical
O
O
O
O
O
O
O
DTS
*
O
O
THX Cinema
O
O
Action/Musical
O
O
O
O
O
O
Mono Movie/Orchestra/
Unplugged/Studio-Mix/
O
O
O
O
O
O
TV Logic
Setting the listening mode parameters
How to set the listening mode parameters
To set the listening mode parameters, you first press the AUDIO
ADJUSTMENT button to select the item and then rotate the
SMART SCAN CONTROLLER to select the parameter.
1. Select the listening mode for which you wish set parameters.
2. Press the AUDIO ADJUSTMENT button until
“Frt Effect=...” appears.
The parameters you can set vary depending on the selected lis-
tening mode. You can press this button to display the available
parameters one by one.
3. Rotate the SMART SCAN CONTROLLER to change the
parameter setting.
4. Press the SMART SCAN CONTROLLER.
2
3
AUDIO
ADJUSTMENT
**
Listening Mode
**
Setup
Listening
Mode=Mono Movie
Front Effect
= ON
Reflect Level = 0dB
Reverb Level
= 0dB
Room Size
=Mid
Default
• Using the on-screen display
If you use the on-screen display to set a listening mode, you can set
the relevant parameters on the same screen.
1. Press the OSD MENU button.
2. Select the “Listening Mode” and press the right edge of the
ENTER/Cursor button.
3. Press the upper or lower edge of the ENTER/Cursor button
to select “Listening Mode.”
Then, press the right or left edge of the button to select the lis-
tening mode.
The parameter items available for the selected listening mode
are displayed.
4. Press the upper or lower edge of the ENTER/Cursor button
to select the item and then press the right or left edge of the
button to set a value.
If you select “LFE Level,” “Setup,” etc., an additional screen
will appear. Set the value for each item in the similar manner.
5. Press the center of the ENTER/Cursor button, or the EXIT
RETURN button, to exit the setup mode.
Default: Select “Default” to reset each parameter to the factory-set
default.
*Available for DTR-6.
(The detailed information on the listening mode parameters is provided on the next page.)
1
PRESET/MODE ADJ
PUSH TO ENTER
PRESET/MODE ADJ
PUSH TO ENTER
SPEAKERS
A
DSP
DSP
THX
/DTS
LISTENING MODE
STEREO
DIRECT
SURROUND