Integra DTR-7 - Manual (Page 51)

51
Using the remote controller
Controlling an Onkyo/Integra MD recorder
Note:
Make sure that you point the transmission part on the remote con-
troller toward the sensor area on the MD recorder.
1. Press the MODE MD/AUX button.
2. Press the desired MD operation button.
Turning the power on and off to the MD recorder
POWER ON/STNBY
: Turning on or standby the power to the MD
recorder
: Down
: Up
: Playback
: Stop
: Rewind
: Fast forward
REC o : Record
: Pause
EJECT r : Eject
1~9, +10 : Numeric keys
ENT : Confirm
You may also use the following buttons:
VOL
∆/∇
: Adjusting the volume level of the receiver
MUTING : Muting the sound from the receiver
Controlling an Onkyo/Integra tape deck
Note:
First connect an Onkyo/Integra tape deck using the zconnection.
(See page 7.)
1. Press the MODE AUDIO/TAPE button.
2. Press the desired tape deck operation button.
: Playback
: Stop
: Rewind
: Fast forward
REC o : Recording/pause
: Reverse playback
You may also use the following buttons:
VOL
∆/∇
: Adjusting the volume level of the receiver
MUTING : Muting the sound from the receiver
MODE MD
MD
operation
buttons
Numeric keys,
ENT button
MODE
AUDIO/TAPE
TAPE
operation
buttons
MODE SAT,
CABLE,VCR,
TV
MODE SAT, CABLE, VCR, and TV buttons
No preset codes are programmed into the MODE SAT, CABLE,
VCR, and TV buttons. You can use these buttons to program remote
controller signals of other devices. (See page 52.)
You may use the following buttons:
VOL
∆/∇
: Adjusting the volume level of the receiver
MUTING : Muting the sound from the receiver