Integra DTR-7 - Manual (Page 56)

56
Erasing a learned remote controller button
operation from the MACRO MODE buttons
1. Press and hold down the corresponding MODE button and
press the MACRO MODE button, then release the buttons.
When you press the MODE button, the SEND/LEARN indica-
tor lights up. When you press the MACRO MODE button, the
indicator turns off. When you release the buttons, the indicator
flashes once.
2. Press the MACRO MODE button again.
The SEND/LEARN indicator flashes twice slowly. The learned
operation is erased.
Using a Macro function
Erasing a learned remote controller button
operation from the MACRO DIRECT button
1. Press and hold down any one of the MODE buttons and
press the MACRO DIRECT button. Then release the but-
tons.
When you press the MODE button, the SEND/LEARN indica-
tor lights up. When you press the MACRO DIRECT button, the
indicator turns off. When you release the buttons, the indicator
flashes once.
2. Press the MACRO DIRECT button again.
The SEND/LEARN indicator flashes twice slowly. The learned
operation is erased.
Notes:
•
If you do not press any button for more than 30 seconds, the SEND/
LEARN indicator flashes three times quickly, then the RC-392M exits
Learning mode. Resume from Step 1.
• If you press a wrong button in Step 2, you may have overwritten the
memory of the button you pressed.
1, 2
1
1
1, 2