To configure mac address aging, To configure unicast mac address forwarding, To configure multicast mac address forwarding – Intel ZT8101 User Manual
Page 107
ZT8101 Users Guide
107
Using the Web Console
To configure MAC address aging
A very long MAC address aging time can result in out-of-date dynamic entries that may cause
incorrect packet filtering and forwarding decisions. A very short aging time may cause entries to be
aged out too soon, which results in a high percentage of received packets whose source addresses
cannot be found in the address table. In this case, the switch must broadcast the packet to all ports,
negating many of the benefits of having a switch.
1. In the left panel, select Forwarding.
2. In the top panel under MAC Forwarding, select MAC Address Aging Time.
3. In the MAC Address Aging Time field, specify the length of time a learned MAC address can
remain in the forwarding table without being accessed (that is, how long a learned MAC
Address is allowed to remain idle). The aging time can be set to any value between 300—
1,000,000 seconds. The default is 300 seconds (5 minutes).
4. Click Apply.
To configure unicast MAC address forwarding
1. In the left panel, click Forwarding.
1. In the top panel under MAC Forwarding, click Unicast MAC Address Settings.
2. Click New and configure these fields.
3. Click Apply.
4. To remove an entry for the Entries list, select the entry and click Delete.
To configure multicast MAC address forwarding
The multicast MAC address settings configure the switch to forward multicast packets from a
specific MAC address to a specified VLAN. The port settings determine which ports can join the
VLAN to forward the multicast packets.
1. In the left panel, click Forwarding.
2. In the top panel under MAC Forwarding, click Multicast MAC Address Settings.
Field
Description
MAC Address
Specifies the unicast MAC address in the packets.
VLAN Name
Specifies the VLAN to which the MAC address belongs.
Type
Specifies whether to forward the packets (Static) or to drop the packets
(BlackHole).
Port
Specifies which port to use for forwarding the packets. This option is not
available if BlackHole is specified as the type.