To configure a link aggregation group, Layer 3 - ip networking, Setting up ip interfaces – Intel ZT8101 User Manual

Page 114: To set up ip interfaces on the switch

Advertising
background image

114

ZT8101 Users Guide

Using the Web Console

You can configure up to six aggregation groups, each using from two to eight ports between any
two ZT8101 switches or other switches that support Etherchannel. Etherchannel is only required
for this first release. In the second release, the ports can be from any switch that is compliant with
802.1ad.

To configure a link aggregation group

1. In the left panel, click Link Aggregation.

2. Select a group to configure and click Edit.

3. Configure these fields for the group.

4. Click Apply.

In addition to the configuration information, the table displays which port has been assigned to be
the anchor port. The anchor port is responsible for the flooding of multicast frames and for sending
control packets.

Layer 3 - IP Networking

This section describes how to configure

IP interfaces

RIP

Multicast routing protocols

Setting Up IP Interfaces

Each IP interface on the switch corresponds to a VLAN. A VLAN, which does not have a
corresponding IP interface defined for it, will function as a Layer 2-only VLAN.

The switch allows ranges of IP addresses (OSI Layer 3) to be assigned to VLANs (OSI Layer 2).
Each VLAN must be configured prior to setting up the corresponding IP interface.

To set up IP interfaces on the switch

1. In the left panel, click Layer 3 IP Networking.

2. In the top panel under IP Interface Settings, click IP Interface Settings.

Field

Description

Starting Port

Specifies the first port in the group. This port’s configuration (speed, full- or
half-duplex, etc.) will be used by all of the ports in the group. This port
becomes the master port.

Group Width

Specifies the number of ports, in sequential order from the master port, that
will be included in the group.

Status

Enables or disables the group.

Advertising