Icom IC-R1500 - Manual (Page 23)

18
5
MEMORY OPERATION
5
■
Programming channel names
Each memory channel can be programmed with an alphanu-
meric channel name for easy recognition and can be indi-
cated independently by channel. Names can be a maximum
of 6 characters— see the table below for available charac-
ters.
q Select the desired memory channel to be programmed.
➥ Push [MR•SKIP] to select memory mode, then rotate
[DIAL] to select the desired memory channel.
w Push [S.MW•MW] to enter select memory write mode.
• “ ! ” indicator and the memory channel number blink.
e Push [TS•MODE] twice to select the memory name pro-
gramming condition, “m nAmE.”
• Frequency readouts disappear and a cursor blinks.
r Rotate [DIAL] to select the desired character.
• The selected character blinks.
t Push [SET•LOCK] to move the cursor to the right.
• Repeat pushing [SET•LOCK] to return to the first digit.
y Repeat steps r and t until the desired channel name is
displayed.
u Push and hold [S.MW•MW] for 1 sec. to program the
name and exit select memory write mode.
(1)
(B)
(L)
(V)
(+)
(2)
(C)
(M)
(W)
(–)
(3)
(D)
(N)
(X)
(/)
(4)
(E)
(O)
(Y)
(=)
(5)
(F)
(P)
(Z)
(6)
(G)
(Q)
(space)
(7)
(H)
(R)
(8)
(I)
(S)
(9)
(J)
(T)
(0)
(A)
(K)
(U)
[EXAMPLE]: Programming “CLUB” into memory channel 12.
Push Push twice
Push for 1 sec. Repeat the
previous
steps.
Beep
Beep
Beep
“
“
“
“
“
Rotate
Push
Select
memory channel.