Icom IC-R1500 - Manual (Page 36)

31
POCKET BEEP AND TONE SQUELCH
8
■
Pocket beep operation
This function uses subaudible tones for calling and can be
used as a “common pager” to inform you that someone has
called while you were away from the receiver.
D Waiting for a call from a specific station
q Set the operating frequency in FM mode.
w Push [SET•LOCK] to enter set mode.
e Push [SET•LOCK] or [S.MW•MW] several times until “Ct”
(when selecting the tone squelch frequency) or “dt” (when
selecting the DTCS code squelch) appears.
r Rotate [DIAL] to select the desired tone frequency or
DTCS code.
t When operating the pocket beep function with DTCS code
squelch, push [SET•LOCK] once then rotate [DIAL] to se-
lect the DTCS polarity.
y Push [TS•MODE] or any key below the display to exit set
mode.
u Push and hold [MONI•T/T-SCAN] for 1 sec to enter tone
squelch selection mode, then rotate [DIAL] until “
S ”
or “ S ” appears to turn the pocket beep function ON
with tone squelch or DTCS squelch, respectively.
[MONI•T/T-SCAN] [DIAL]
Appears when the pocket beep
with tone squelch is turend ON. Appears when the pocket beep
with DTCS squelch is turned ON.
DTCS polarity setting
[DIAL]
Tone squelch frequency setting DTCS code setting
[SET•LOCK]