Icom IC-R1500 - Manual (Page 52)

47
10
OTHER FUNCTIONS
■
Partial reset
If you want to initialize the operating conditions (VFO fre-
quency, VFO settings, set mode contents) without clearing
the memory contents, a partial reset function is available.
➥ While pushing [V/MHz•SCAN] and [SET•LOCK], push and
hold [PWR] for 1 sec. to reset CPU partially.
■
All reset
The function display may occasionally display erroneous in-
formation (e.g. when first applying power). This may be
caused externally by static electricity or by other factors.
If this problem occurs, turn power OFF. After waiting a few
seconds, turn power ON again. If the problem persists, per-
form the following procedure.
• Partial resetting is also available. See left for details.
IMPORTANT!:
Resetting the receiver CLEARS all memory information
and initializes all values in the receiver to their default set-
tings.
➥
While pushing [S.MW•MW] and [SET•LOCK], push and
hold [PWR] for 1 sec. to reset the CPU.
[S.MW•MW]
[SET•LOCK] [PWR]
AT POWER ON
[S.MW•MW]
[PWR]
[V/MHz•SCAN]
AT POWER ON