John Deere GT2554 - Manual (Page 13)

Assembly - 9
ASSEMBLY
4. Remove dipstick to check oil level.
5. Oil must be between add and full marks.
6. Add oil to full mark if necessary. Do not overfill.
7. Install and tighten dipstick. Lower hood.
Break-In Electric PTO Clutch
MX13482
1. Start engine and push throttle lever (A) up to full throttle
(r) position.
2. With no load on mower, engage PTO (B) and allow
mower to run for 10 seconds.
3. Disengage PTO and wait 10 seconds.
4. Repeat Steps 2 and 3 for 12-15 cycles.
5. PTO clutch is now properly burnished.
Check Machine Safety System
Perform safety system check to make sure electronic safety
interlock circuit is functioning properly. Perform all safety
system tests.
Checking Tire Pressure
1. Check tires for damage.
2. Check tire pressure with an accurate gauge.
3. Add or remove air, if necessary:
B
A
c
CAUTION: Avoid injury! Explosive separation
of tire and rim parts is possible when they are
serviced incorrectly:
• Do not attempt to mount a tire without the
proper equipment and experience to perform
the job.
• Do not inflate the tires above the
recommended pressure.
• Do not weld or heat a wheel and tire
assembly. Heat can cause an increase in air
pressure resulting in an explosion. Welding
can structurally weaken or deform the wheel.
• Do not stand in front or over the tire
assembly when inflating. Use a clip-on chuck
and extension hose long enough to allow you
to stand to one side.
Tire Size Air Pressure
Front: 16 x 7.50 83 kPa (12 psi)
Rear: 24 x 12.00 69 kPa (10 psi)