John Deere GT2554 - Manual (Page 23)

Operating - 19
OPERATING
Dismounting to Inspect or Unplug Mower or
Optional Bagger
1. Stop machine.
2. Push PTO switch down to disengage mower.
3. Move throttle lever midway between slow and fast
positions. Let engine run a minimum of 15 seconds.
4. Lower mower to ground.
5. Lock park brake.
6. Stop engine.
7. Remove key.
8. Wait for all moving parts to stop.
Pushing Machine
To move machine when engine is stopped:
MX13483
1. Unlock park brake (A).
MX13510
2. Pull out on free-wheeling lever (B).
3. Push machine to desired location.
NOTE: Push free-wheeling lever (B) in before operating
machine.
Using Reverse Implement Option
NOTE: Operating mower while backing up is strongly
discouraged. Reverse Implement Option should be
used only when operating another attachment or when
operator deems it necessary to reposition machine
with mower engaged.
1. Stop machine forward travel with attachment still
engaged.
2. Look behind machine to be sure there are no
bystanders.
MX13482
3. Lift and hold PTO knob (A) up past PTO engagement
position to activate reverse implement position while
depressing reverse foot pedal slightly.
c
CAUTION: Avoid injury! Do following steps
before dismounting to inspect or unplug
mower or bagger.
IMPORTANT: Avoid damage! Do not tow machine.
A
c
CAUTION: Avoid injury! Before moving forward
or rearward, make sure area is clear of
bystanders, especially children.
B
A