JVC SR-VS30EK - Manual (Page 44)

Filename [SR-VS30EK_3-EN.fm]
Masterpage:Left
44
Page 44 February 1, 2002 2:04 pm
EDITING
Tape Dubbing
(from DV to VHS)
Dubbing An Entire Cassette
Because this recorder includes both VHS deck and DV deck, you
can easily use it for dubbing without connecting any other
equipment.
A
Load cassettes.
For the VHS deck
Insert a VHS (or S-VHS) cassette with the record safety
tab intact, or cover the hole using adhesive tape.
For the DV deck
Insert a Mini DV cassette with the erase protection switch
set to “SAVE”.
B
Select the dubbing direction.
Press .
● The dubbing direction indicator (DV ) lights.
C
Set the tape speed.
Press VHS, then press SP/LP ( p ).
● “DV ] VHS” appears on the TV screen if “O.S.D.” is set to
“ON”. (
੬
pg. 67)
D
Start dubbing.
Press DUB for more than 2 seconds.
● DV playback indicator and VHS recording indicator light.
● If the tapes have not been rewound, both decks rewind
automatically. The VHS deck goes into Record Pause mode,
and the DV deck goes into Pause mode.
When both decks have finished rewinding, dubbing begins
automatically.
After dubbing is completed, the decks rewind both tapes
automatically and eject them. The recorder then shuts off.
NOTES:
● If you set the dubbing direction incorrectly, you could erase an
important recording that you wanted to copy. It is
recommended to conduct a test with unimportant cassettes
first.
● If you start dubbing a tape from a tape with a copy protection
signal, the tapes will be automatically ejected, and the
recorder will turn off.
● To cancel the dubbing mode, press PR +/– so that the dubbing
direction indicator (DV ) goes off.
1 2 3
4 5 6
7 8 9
1
2
1
2
3
0
3
4
4
1 3 2
SR-VS30EK_1.book Page 44 Friday, February 1, 2002 2:31 PM