JVC SR-VS30EK - Manual (Page 82)

Filename [SR-VS30EK_4-EN.fm]
Masterpage:Left
82
Page 82 February 1, 2002 2:16 pm
SUBSIDIARY SETTINGS (cont.)
VIDEO Plus+
®
System Setup
Guide Program Number Set
A
Access the Main Menu screen.
Press MENU.
B
Access the Initial Set screen.
Press
rt
to move the highlight bar (pointer) to “INITIAL
SET”, then press OK or
e
.
C
Access the Guide Program Set screen.
Press
rt
to move the highlight bar (pointer) to “GUIDE
PROG SET”, then press OK or
e
.
D
Enter the Guide Program number.
Press
rt
to enter the Guide
Program number for the desired
station as shown in the TV
listings. Then press OK or
e
.
E
Enter the receiving channel position number.
F
Return to the normal screen.
Press MENU.
IMPORTANT
Normally, Auto Set Up (
੬
pg. 13), Preset Download (
੬
pg. 14) or Auto Channel Set (
੬
pg. 72) sets the Guide Program numbers
automatically. You need to set the Guide Program numbers manually only in the following cases.
● When timer-programming with the VIDEO Plus+ system, the channel position, where the station you wish to record is received
on your recorder, is not selected,
OR
when you add a channel after Auto Set Up, Preset Download or Auto Channel Set has taken place,
—Set the Guide Program number for that station manually.
● When you wish to timer-record a satellite programme with the VIDEO Plus+ system,
—Set the Guide Program numbers for all satellite broadcasts received on your satellite receiver.
Turn on the TV and select the AV mode.
(Example) When inputting the
Guide Program
number 4 for CH4.
Press the number key “0” to
select “TV PROG” or “SAT”.
Then press
rt
to input the
number of the recorder’s
channel position on which the
Guide Program number’s
broadcast is received by the
recorder or the satellite
receiver. Then press OK or
e
.
● To timer-record a satellite
programme with the VIDEO
Plus+ system, you need to install
the provided Satellite Controller
and perform the procedure
described in “Satellite Receiver
Control Setting” (
੬
pg. 17).
● Repeat steps 4 and 5 as
necessary.
(Example) If CH4 is received on
channel position 4.
Guide Program Number
“Guide Program (GUIDE PROG) number” refers to the
assigned TV station numbers, according to broadcast area,
for the VIDEO Plus+ timer recording. The Guide Program
numbers can be found in most TV listings.
SR-VS30EK_1.book Page 82 Friday, February 1, 2002 2:33 PM