JVC SR-VS30EK - Manual (Page 49)

Masterpage:Right-Full-NoTitle0
49
Filename [SR-VS30EK_3-EN.fm]
Page 49 February 1, 2002 6:07 pm
Simultaneous Dubbing
It is possible to perform recording simultaneously on both the VHS deck and the DV deck from the same external input.
A Press AUX (number key “0”) and /or PR to select the appropriate input mode depending on the connectors being used.
B Press DV to select the DV deck. Press and hold 9 and press 7 so that the DV deck enters the Record Pause mode.
C Press VHS to select the VHS deck. Press and hold 9 and press 7 so that the VHS deck enters the Record Pause mode.
D Engage the Play mode of the connected device.
E Press 4 to start recording on both the VHS deck and DV deck.
F Press 8 to stop recording on the VHS deck.
G Press DV to select the DV deck, then press 8
to stop recording on the DV deck.
NOTE:
It is not possible to record a TV programme on both the VHS deck and the DV deck simultaneously.
1 3 2
1 3 2 1 3 2
B
If the camcorder has an S-VIDEO output connector ...
Video cable
(not provided) AUDIO OUT Camcorder
AUDIO input
Player
VIDEO input
EDIT
Audio cable
(not provided)
Mini-plug cable
(not provided)
(JVC camcorder only)
PAUSE
connector
Recorder
Audio cable
(not provided)
AUDIO OUT Camcorder
S-VIDEO input
Player
AUDIO
input
S-VIDEO OUT
S-Video cable
(not provided)
Mini-plug cable
(not provided)
(JVC camcorder only)
PAUSE
connector
Recorder
VIDEO OUT
A
If the camcorder has no S-VIDEO output connector ...
EDIT
C
If the camcorder has a DV IN/OUT connector ...
Camcorder
Player
Mini-plug cable
(not provided)
(JVC camcorder only)
PAUSE
connector
Recorder
EDIT
DV IN/OUT
DV cable (VC-VDV204)
(not provided)
DV IN/
OUT
NOTES:
About DV IN/OUT connector
● To output digital signal when dubbing from the VHS deck to
other device through the DV IN/OUT connector, press , and
then press 4 to start playback on the VHS deck.
● To input digital signal when dubbing from other device to the
VHS deck through the DV IN/OUT connector, press then
VHS , and then press 7 to start recording on the VHS deck.
● It is possible to control the DV deck from the AVC protocol-
equipped device that is connected to the DV IN/OUT connector.
To control the VHS deck, use the buttons on this recorder and
the remote control.
● All necessary cables can be obtained from your dealer.
● When you select “EDIT” to dub tapes in step 4, be sure to select
“AUTO” (or “NORM” when “B.E.S.T.” is set to “OFF”) after you
finish dubbing the tapes.
● When you are editing through the DV IN/OUT connector, the
recorder will stop if signal is interrupted.
● When connecting this recorder to a device equipped with a DV
input connector, be sure to use the optional DV cable
(VC-VDV204).
SR-VS30EK_3-EN.fm Page 49 Friday, February 1, 2002 6:07 PM