JVC SR-VS30EK - Manual (Page 46)

Filename [SR-VS30EK_3-EN.fm]
Masterpage:Left
46
Page 46 February 1, 2002 2:04 pm
EDITING (cont.)
Normal Dubbing
(from DV to VHS)
NOTES:
● If you set the dubbing direction incorrectly, you could erase an
important recording that you wanted to copy. It is
recommended to conduct a test with unimportant cassettes
first.
● There may be a discrepancy of several seconds between
where you intend editing to start, and where it actually starts.
● The superimposed indication during the operation or dubbing
is not recorded.
● To cancel the dubbing mode, press PR +/– so that the dubbing
direction indicator (DV ) goes off.
● When dubbing a Mini DV tape that was produced by audio
dubbing, you need to set “12BIT MODE” to the appropriate
mode before playing back the tape. (
੬
pg. 71)
You can dub selected scenes on a tape, starting and stopping
wherever you wish.
A
Load cassettes.
For the VHS deck
Insert a VHS (or S-VHS) cassette with the record safety
tab intact, or cover the hole using adhesive tape.
For the DV deck
Insert a Mini DV cassette with the erase protection switch
set to “SAVE”.
B
Select the dubbing direction.
Press .
● The dubbing direction indicator (DV ) lights.
C
Set the tape speed.
Press VHS, then press SP/LP ( p ).
● “DV ]
VHS” appears on the TV screen if “O.S.D.” is set to
“ON”. (
੬
pg. 67)
D
Locate the start point on the DV deck.
A Press DV.
B Press 4 to start playback.
C Press 9 to pause playback a little before the start
point.
E
Prepare the VHS deck for dubbing.
A Press VHS.
B Press and hold 9 and press 7 so that the VHS deck
enters the Record Pause mode.
● DV playback indicator and VHS recording indicator light.
F
Start dubbing.
Press START.
G
Pause dubbing.
Press START.
● The VHS deck enters the Recording Pause mode, then the DV
deck enters the Dubbing Pause mode.
H
End dubbing.
Press 8 to stop recording on the VHS deck. Then press
DV and press 8 to stop playback on the DV deck.
1 2 3
4 5 6
7 8 9
1
2
1
2
3
0
3
4
4
1 3 2
SR-VS30EK_1.book Page 46 Friday, February 1, 2002 2:31 PM