John Deere HR-BG5002 - Manual (Page 14)

4 Operator’s Manual
Operation
WaRnInG: neVeR COnneCT yOuR GaS GRIll TO an
lP GaS CylIndeR WITHOuT THe ReGulaTOR
PROVIded, and neVeR TO an unReGulaTed lP
GaS SuPPly. THe GaS ReGulaTOR SuPPlIed
WITH THe aPPlIanCe MuST Be uSed.
alWayS leaK TeST THe lP GaS CylIndeR TO
ReGulaTOR COnneCTIOn WHen COnneCTInG
THe lP GaS CylIndeR TO THe aPPlIanCe. See
“leaK TeSTInG”.
dO nOT OPeRaTe aPPlIanCe If THe SMell Of
lP GaS IS PReSenT. exTInGuISH all flaMe
and deTeRMIne SOuRCe Of lP GaS BefORe
PROCeedInG. dO nOT IGnITe THe aPPlIanCe
unTIl THe lP GaS leaK HaS Been fOund and
Sealed.
CauTIOn: alWayS SHuT Off lP GaS CylIndeR ValVe
WHen THe aPPlIanCe IS nOT In uSe.
lIGHTInG GRIll
. The appliance must be assembled as per the assembly
instructions.
. Check that your gas cylinder is full and properly connected to the
regulator.
. Check that there are no gas leaks in the gas supply system. See
“Leak Testing”.
4. Check that the venturi tubes are properly located over the gas valve
orifices.
5. Check that both Main Burner and Side Burner ignition wires are
connected.
6. Read carefully all instructions contained on the information plate
attached to the grill.
WaRnInG: OPen lId BefORe lIGHTInG.
7. Set control knobs to “OFF” and turn on the gas supply.
8. Main Burner:
a. Push and turn right control knob to “Hi”.
b. Push the ignitor knob  or 4 times or match light. Burner should
ignite within 5 seconds. (Ignition may perform better with right
control knob or both control knobs set at medium.)
Note: To light burner with a match follow steps 1 thru 7 above.
c. Insert lighted match through lighting hole located at the bottom right of
the grill housing.
d. Push and turn right control knob to “Hi”.
e. Burner should ignite within 5 seconds.
f. After the right burner is lit, push and turn left control knob to “Hi”.
Left burner will ignite automatically.
A. LEFT BURNER CONTROL
B. RIGHT BURNER CONTROL
C. SIDE BURNER CONTROL
D. IGNITOR
E. MANUAL LIGHTING HOLE F. HANDLE
G. SIDE BURNER
H. CYLINDER VALVE
I. REGULATOR