JVC HR-J4006UM - Manual (Page 47)

EN
13
Simple
Recording
LOAD A CASSETTE
1
Make sure the record safety tab is intact. If not, cover the
hole with adhesive tape before inserting the cassette.
SELECT RECORDING
CHANNEL
2
Press CH 5∞. Or press the appropriate NUMBER keys,
then press ENTER. (The channel changes after a few
seconds whether you press ENTER or not.)
● If you use the RF connection, by pressing the TV/VCR
button, select VCR mode to view the program to be
recorded.
SET TAPE SPEED
3
Press SP/EP to set the recording speed.
START RECORDING
4
Press and hold REC and press PLAY on the remote
control, or press REC on the VCR's front panel.
B.E.S.T. takes place at the beginning of both the first
SP and the first EP recording after inserting the
cassette (when B.E.S.T. is set to "ON",
੬
pg. 20).
PAUSE/RESUME
RECORDING
5
Press PAUSE. Press PLAY to resume recording.
● During record pause, you can change the recording
channel by using the CH 5∞ buttons or NUMBER
keys.
B.E.S.T. will not take place if the tape speed is
changed while in record pause mode.
STOP RECORDING
6
Press STOP or STOP/EJECT. Then press STOP/EJECT to
remove the cassette.
Turn on the TV and select the VCR channel 3 or 4 (or AV
mode).
1 2 3
4 5
0
6
7 8 9
•• ••
1
2
4
3
PAUSE
STOP
REC
PLAY
CH
TV/VCR
● To prevent accidental recording on a recorded cassette,
remove its record safety tab.
To record on it later, cover the hole with adhesive tape.
Accidental erasure prevention
Record safety tab
PAUSE
STOP/EJECT
REC
PLAY
CH
NUMBER
ENTER
SP/EP
Recording Resume Function
If there is a power outage during recording (or Instant Timer
Recording or timer recording), the recording will resume
automatically when power is restored to the VCR.