Jacuzzi BY82000 - Manual (Page 11)

TOWERS AND DOORS INSTALLATION
STEP 4
Take the side support rails and install a cover cap and wall bracket on each end. Place the center support rail into slot
on each tower. If rail does not readily fit into slots, it may be necessary to loosen the bolts holding towers to base (it
may only be necessary to loosen one tower). DO NOT FORCE CENTER RAIL INTO SLOTS. With center support rail
in position, install hold down brackets but do not tighten screws. Place the side support rails into the slot on each water
tower. With side rails in position install hold down brackets, but do not tighten screws. Check side support rails for
level and mark on the finished wall where to attach rail bracket. See DETAIL A. Drill 3/16" holes and secure bracket
with screws and wall anchors provided. Slide cover cap over rail bracket. If a tower bolt was loosened, retighten while
checking the plumb of the tower. Tighten screws on all hold down brackets.
CENTER SUPPORT RAIL
HOLD DOWN BRACKETS (5)
COVER CAP (2)
RAIL BRACKET (2)
SIDE SUPPORT RAIL (2)
WATER TOWER DOOR POST WATER TOWER JAMB
RAIL HOLD
DOWN BRACKET
(1 PER AIR TOWER)
SCREW (8 PER WATER TOWER)
(4 PER AIR TOWER)
(2 PER WATER TOWER)
ATTACH RAIL
BRACKET TO WALL
SECURE RAIL TO
BRACKET (TURN CW
TO TIGHTEN)
MOVE COVER CAP
OVER BRACKET
DETAIL A
9
Jacuzzi Whirlpool Bath © BY82000 03/05