Jacuzzi BY82000 - Manual (Page 13)

TOWERS AND DOORS INSTALLATION
STEP 6
Move the door assembly to the door post on water tower
and slide the assembly into the door post. Locate the
base of the door into the slot of serrated door positioner
that positions the hinge barrel as shown.
BOTTOM OF
DOOR FRAME
HINGE BARREL
SHOWER BASE
WATER
TOWER
GLASS DOOR
STEP 7
Check that the magnetic mouldings on door and air
tower overlap. Insert adjusting bolt with locking nut into
fixed nut in top cap (See below). Adjust the door with
adjusting screw until the glass is parallel with shower
base and door moulding mates with water tower mould-
ing. It may be necessary to reposition the door into
another slot (See STEP 6) which can be done without
removing door from wall post. To do so remove the
adjusting screw from wall post, lift the door slightly to
reposition. Reinsert adjusting screw and locking nut and
adjust glass door. After final adjustment, lock this posi-
tion with locking nut. Repeat for other door.
LOCKING
NUT
ADJUSTING
SCREW (12mm)
DOOR POST
HINGE
BARREL
STEP 8
Install cover cap by sliding over adjusting screw and
bracket.
COVER CAP
11
Jacuzzi Whirlpool Bath © BY82000 03/05