JVC VN-V686WPU - Manual (Page 59)

59
D Preset Position
Speed This item sets the speed of moving to the preset position. It is also applicable
when moving to the preset position in Auto Patrol.
[Setting values : 1 to 4]
Speed
E Auto Flip Set this item when shooting objects that pass right under the camera.
Otherwise, following operations are necessary to shoot objects that pass
right under the camera.
ATurn the camera to face down
BRotate the camera 180
Њ horizontally
CTurn the camera to face up
You can use the [Auto Flip] function to perform the above operations
automatically.
Off
: Auto Flip function does not activate.
Digital Flip
: The top/bottom and left/right of the image flips when tilt position passed
the angle of 135 degrees.
Mode1: When the camera faces bottom, it rotates 180 Њ horizontally and stops.
In this case, the operating direction of the camera is the same as that of
the Pan/Tilt operation.
Mode2: When the camera faces bottom, it rotates 180 Њ horizontally and the
operating direction of the camera is opposite that of the Tilt operation.
Select this mode if you wish to operate continuously. Once operation
stops, the direction will return to normal.
Mode3: When the camera faces bottom, it rotates 180 Њ horizontally and the
operating direction of the camera is opposite that of the Tilt operation.
However, the operating direction will return to normal 10 seconds after
the operation has stopped.
[Setting values : Off, Digital Flip, Mode1, Mode2, Mode3]
Memo :
● Settings for [Preset Position Speed] are reflected in the rotation speed when
images are flipped using AMode1B, AMode2B, AMode3B. To flip images in high
speed using AMode1B, AMode2B, AMode3B, set the [Speed] in [Preset
Position Speed] to A4B.
Note：
● When [Auto Flip] is set to other than AOffB, the camera can be moved to areas
outside the pan limit with the Tilt operation. When ADigital FlipB is set, use the
Tilt operation to flip and return to the pan limit area again. When AMode1B,
AMode2B or AMode3B is set and the camera is moved to inside of the pan
limit with Pan operation, it will stop at the pan limit position.
VN-V686WPU_EN.book Page 59 Friday, February 8, 2008 5:20 PM