JVC KD-AV7000 - Manual (Page 263)

3
2 1
53 mm
184 mm
(7-1/4")
(2-1/8")
!
Ÿ
~
⁄
@
l
s
p
k
d
c
A
B
B
m
n
l
r q
p
2 1
i
INSTALLATION
The following illustration shows a typical installation. However, you
should make adjustments corresponding to your specific car. If
you have any questions or require information regarding installation
kits, consult your JVC car audio dealer or a company supplying
kits.
Å Installing the main unit (in-dash mounting)
!"#$%&'()*+,-./0123451&6
!"#$%&'()*+,-./012345678
JVC !"#$%&'()*+,-./0123
Å !" #$%&'()*+,
°“√µ‘¥µ—Èß
¿“жµ—«Х¬Л“ßµËÕ‰ªπ’И· ¥Я∂чЯ°“√µ‘¥µ—ИЯ·∫∫∑—Л«‰ª Х¬Л“Я‰√°Бµ“¡∑Л“π§«√ª√—
∫·µЛЯ„АИ‡А¡“– ¡°—∫√∂¬πµП А“°¡’§”∂“¡ А√◊ÕµÈÕß°“√¢ÈÕ¡Ÿ≈‡°’Л¬«°—∫™я¥Хяª°
√≥Пµ‘¥µ—Èß „АИª√ч°…“µ—«·∑π®”АπЛ“¬‡§√◊ЛХЯ‡ ’¬Я√∂¬πµП¢ХЯ JVC А√◊Х∫√‘…—
∑ºŸИ¢“¬Хяª°√≥П¥—Я°≈Л“«
Е
°“√µ‘¥µ—ИЯµ—«‡§√◊ЛХЯ (°“√ª√–°Õ∫·ºßÀπÈ“ª—¥)
Do the required electrical connections.
!"#$% &
µËÕ “¬‰шµ“¡∑’Л°”А𥉫И∑—ИЯА¡¥
Bend the appropriate tabs to hold the sleeve
firmly in place.
!"#$%&'( !)*+,-.
ßÕ·ºЛπ‡ж◊ЛХ¬ч¥ª≈Х°„АИ·πЛπ‡¢И“∑’Л
Removing the main unit
Before removing the main unit, release the rear section.
!
!"#$%&'!()*+,-./)01
°“√∂Х¥™я¥ª√–°Õ∫
°ЛХπ∂Х¥™я¥ª√–°Õ∫ „ÀȪ≈¥ÀπÈ“µ—¥ Ë«π∑È“¬°ËÕπ
Insert the two handles, then pull them as illustrated so that the unit can be removed.
!"#$%&'()*+,-."/01234$5678$%)*"9:;
!
„ ˧—π∫—Я§—∫ 2 Х—π≈ß„π√ЛХЯ ”А√—∫„™Иж—π≈«¥¥—Я¿“ж ®“°π—Иπ„АИ‡≈◊ЛХπ™я¥ª√–°Х∫ХХ° „π¢≥–∑’Л§ЛХ¬К ¥чЯ§—
π∫—Я§—∫∑—ИЯ ХЯХХ°®“°°—π
When installing the unit without using the sleeve / !"#$%&'($ /
‡¡◊ËÕµ‘¥µ—ИЯ™я¥ª√–°Х∫‚¥¬‰¡Л „™Иª≈Х°АяИ¡
In a Toyota for example, first remove the car radio and install the unit in its place.
!"Toyota !"#$%&' ()*+,-./*0123'4567
µ—«Х¬Л“Я‡™Лπ „π√∂¬πµÏ‚µ‚¬µИ“ „АИ∂Х¥«‘∑¬яµ‘¥√∂¬πµÏÕÕ°°ËÕπ·≈–µ‘¥µ—ИЯ™я¥ª√–°Õ∫π’И‡¢И“‰ª·∑π
Note : When installing the unit on the mounting bracket, make sure to use screws of proper length
refering to the table above. If longer screws are used, they could damage the unit.
!"#"$%&'()*+,-./&01234567'89:;23<4'89
!"#$%&
À¡“¬‡Àµÿ : ¢≥–µ‘¥µ—ИЯ‡§√◊ЛХЯ∫π·∑Лπ√ХЯ ¢Х„АИ¥Ÿ„ÀÈ·πЛ„®«Л“„™И °√Ÿ∑’Л¡’§«“¡¬“«‡А¡“– ¡ µ“¡∑’Л√–∫я„πµ“√“Я¢И“ßµÈπ
А“°„™И °√Ÿ¬“«°«Л“∑’Л√–∫яХ“®∑”„АИ‡§√◊ЛХЯ‡ ’¬‰¥И
When using the optional stay / !"# / ‡¡◊ËÕ„™Иµ—«¬ч¥·∫∫‡≈◊Х°‰¥И
(“¡“√∂‡≈◊Х°‡ª‘¥§И“Я‰«И ‰¥И)
Screw (option)
!"#$%
°√Ÿ (‡≈◊Х°‰¥И)
Stay (option)
!"#$%
µ—«¬ч¥ (‡≈◊Х°‰¥И)
Fire wall
ºπ—ß°—π‰ø
Dashboard
·ºßÀπÈ“ª—∑¡Ï
Install the unit at an angle of less than 30˚, taking it into
account that the monitor would eject when in use (see
below).
!"#$% 30˚ =E !F
µ‘¥µ—ИЯ™я¥ª√–°Х∫∑’Л¡я¡µЛ”°«Л“ 30˚ ХЯ»“ (¥Ÿ∑’Л¥И“π≈Л“Я)
30˚
Tapping screws (not supplied)
!"#$%&'(
°√Ÿ‡°≈’¬« (‰¡Л‰¥И„АИ¡“ж√ИХ¡‡§√◊ЛХЯ)
Floor
æ◊Èπ√∂
ı Installing the hideaway unit (under the front
seat) ı !"#$%&'()* ı °“√µ‘¥µ—ÈßÕÿª°√≥П ”А√—∫µ‘¥µ—ИЯ¥И“π„π („µÈ‡∫“–ÀπÈ“)
• Be sure to use the tapping screws (not supplied) of appropriate length so that they
will not damage any parts of the car.
• !"#$%&'()*+,-./012345678&9:;<=
• ¥Ÿ„ÀÈ·πЛ„®«Л“„™И °√Ÿ‡°≈’¬« (‰¡Л‰¥И„АИ¡“ж√ИХ¡‡§√◊ЛХЯ) ∑’Л¡’§«“¡¬“«‡А¡“– ¡ ‡ж◊ËÕªÈÕß°—
π‰¡Л„АИ‚¥π Ë«πÕ◊Лπ¢ХЯ√∂‡ ’¬А“¬
* 2 Not included with this unit.
* 2 = !"#$%
* 2 ‰¡Л‰¥И„АИ¡“°—∫™я¥ª√–°Õ∫π
Required space for the monitor ejection
!"#$%&
æ◊Иπ∑’Л«Л“Я∑’˵ÈÕß°“√ ”À√—∫¥—π®Х¿“жХХ°
177
51.8
143.3
15
12.2
Use the following screws
!"#
„™È °√Ÿ¥—Яπ’И
For No.1 – 5 M5 x 8 mm* 2
For No.6 – 9 M4 x 3 mm* 2
1 5 M5 x 8 mm* 2
6 9 M4 x 3 mm* 2
”А√—∫А¡“¬‡≈¢ 1 – 5 M5 x 8 ¡¡ * 2
”А√—∫А¡“¬‡≈¢ 6 – 9 M4 x 3 ¡¡ * 2
mm
mm
¡¡
Flat type screws* 2
!"* 2
°√ŸÀ—«‡√’¬∫ * 2
Bracket* 2
* 2
‡А≈Б°¬ч¥ * 2
Pocket
°–‡ª“–
1 2 3 4 5
6 7 8 9
Attach the sleeve-mounting plates—either type, corresponding to the
depth of the mounting area (
A : see the next step).
Use Type B when A is 165 mm while use Type A when A is less
than 165 mm
!"# $%&'$( $)*+,-./
E
A !"#$%&
!=B = A 165 mm = A = A = 165 mm
µ‘¥·ºЛπ∑’Л„™И„π°“√µ‘¥µ—ИЯª≈Х°АяИ¡у·∫∫„¥°Б‰¥И „АИжХ¥’°—∫§«“¡≈ч°¢ХЯ™ЛХЯ∑’Л®–µ‘¥µ—Èß
(A : ¥Ÿ¢—ÈπµÕπ∂—¥‰ª)
„™È·∫∫ B ‡¡◊ËÕ A ¡’¢π“¥ 165 ¡¡ ·≈–„™È·∫∫ A ‡¡◊ËÕ A ¡’¢π“¥πИХ¬°«Л“ 165 ¡¡
KD-AV7005(Pg1)[f] 1/10/04, 05:51 PM 3