JVC KD-AV7000 - Manual (Page 348)

4
Headphones (not supplied)* 4
D Connecting the cradle
By using the cradle (KV-CR100), you can remove the monitor from the main unit and insert it into the cradle so that the persons
sitting on the rear seat can view the playback picture even while the driver are driving your car.
• The driver must not put on the headphones while driving. It is dangerous to shut off the outside sounds while driving.
• Additional monitor (KV-MAV7001) can also be purchased to used so that you do not need to remove the monitor from the main
unit.
KV-CR100
Main unit
Removable monitor or additional
monitor KV-MAV7001*
3
AV bus cable supplied for KV-CR100
After removing the monitor from the main unit, insert the blind
cover into the main unit to prevent internal dust accumulation.
Hold
Stereo mini plug (∅ 3.5 mm)
o * 3 When not in use, store the monitor in the supplied soft case for its
protection.
* 4 To listen to source sound while in Dual Mode operations.
See page 33 of the INSTRUCTIONS (separate volume).
MULTIMEDIA DVD/CD RECEIVER WITH REMOVABLE MONITOR HIDEAWAY UNIT KD-AV7008
AV INPUT 1 L R AUDIO FM / AM ANTENNA
POWER
BACKCAMERA REMOTE
CENTER SPEAKER
CENTER
SUB WOOFER
L
R REAR
L
R FRONT
VIDEO AV INPUT 2 L R AUDIO VIDEO TO CHANGER AV BUS TO MAIN UNIT
PRE OUT
AUDIO VIDEO L R
AV OUTPUT
L R L
L
INPUT
INPUT INPUT
R
L
INPUT
R
L
R
L
R
R
JVC Amplifier
Rear speakers
Front speakers
JVC Amplifier
Subwoofer
Center speaker
E Connecting the external amplifiers
You can connect amplifiers to upgrade surround system in the car compartment.
• Connect the PRE OUT terminals of the hideaway unit to the amplifier’s line-in terminals.
• Disconnect the speakers from the hideaway unit, connect them to the amplifier. Leave the speaker leads of the unit
unused.
* 5 Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint (if coated with
paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.
* 5
* 5
* 5
* 5
F Connecting the back camera lead
Locate the back lamp lead in the trunk.
Back lamp lead
JVC Amplifier
JVC Amplifier
If you connect the remote lead (blue with white stripe) to the remote lead of the other equipment, they can be turned on and off
automatically with this unit.
Remote lead
Y-connector (not supplied with this unit)
Remote lead (Blue with white stripe)
Hideaway unit To the remote lead of other equipment
JVC Amplifier
Back lamps
BACK
CAMERA
To back lamp To car battery
Back lamp lead
TROUBLESHOOTING
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• Noise interfere with sounds.
* Is the rear ground terminal connected to the car’s chassis using
shorter and thicker cords?
• Unit becomes hot.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
InstallKD-AV7008_2[A]5.p65 04.10.5, 3:49 PM 4