John Lewis JLDWW 1205 - Manual (Page 21)

5. To memorise the operation, switch off the
dishwasher by pressing the On/off
button.
If you decide to revert back to
the use of individual detergents
we advise that you:
1. Deactivate the Multi tab function.
2. Fill up the salt container and the
rinse aid dispenser again.
3. Adjust the water hardness setting
to the highest setting and perform
1 normal washing programme
without loading any dishes.
4. Adjust the water hardness setting
according to the hardness of the
water in your area.
5. Adjust the rinse aid dosage.
Select and start a washing
programme
Select the washing programme
and delay start with the door
slightly opened. The start of the
programme or the countdown of
the delay start will occur only
after the closure of the door.
Until then it is possible to modify
the settings.
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the On/Off button. The dishwasher
must be in setting mode.
4. Press one of the two programme buttons
to select a washing programme. When a
programme is selected the corresponding
programme light illuminates and the
programme time flashes on the digital
display.
For the selection of the washing
programme see "Washing programmes"
chart.
Close the dishwasher door, the
programme starts automatically. In the
digital display the programme time is no
longer flashing but fixed with static light.
The selection of the washing programme can
be made with the door closed. Keep in mind
that this way, once a washing programme has
been selected you have ONLY 3 seconds in
which you can select: another washing
programme, delay start and half load option.
After these 3 seconds the selected
programme will start automatically.
21