John Lewis JLDWW 1205 - Manual (Page 25)

Something not working
The dishwasher will not start or stops during
operation.
Certain problems are due to the lack of simple
maintenance or oversights, which can be
solved with the help of the indications
described in the chart, without calling out an
engineer.
Switch off the appliance and carry out the
following suggested corrective actions.
Important! If you call out an engineer to a
fault listed below, or to repair a fault caused
by incorrect use or installation, a charge will
be made even if the appliance is under
guarantee.
Fault code and malfunction Possible cause and solution
• appears in the digital display
The dishwasher does not fill with
water
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the threaded hose fitting at
the water inlet valve is blocked.
Clean the filter in the threaded hose.
• The water inlet hose has not been correctly laid or it is
bent or squashed.
Check the water inlet hose connection.
• appears in the digital display
The dishwasher will not drain
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid or it is
bent or squashed.
Check the water drain hose connection.
• appears in the digital display
Anti-flood device is activated
• Close the water tap and contact our extended warranty
administrators, refer to Repairs-After Sales Service on the
following pages.
25