John Lewis JLDWW 1205 - Manual (Page 30)

This appliance has been fitted with
safety features which will prevent the
water used in the appliance from
returning back into the drinking water
system. This appliance complies with
the applicable plumbing regulations.
Water inlet hose with
safety valve
After connecting the double-walled water
inlet hose, the safety valve is next to the tap.
Therefore the water inlet hose is only under
pressure while the water is running. If the
water inlet hose starts to leak during this
operation, the safety valve cuts off the running
water.
Please take care when installing the water inlet
hose:
• The electrical cable for the safety valve is in
the double-walled water inlet hose. Do not
immerse the water inlet hose or the safety
valve in water.
• If water inlet hose or the safety valve is
damaged, remove the mains plug
immediately.
• A water inlet hose with safety valve must
only be replaced by a local repair agent.
Warning! Dangerous voltage
Water outlet hose
connection
The end of the drain hose can be connected
in the following ways:
1. To the sink outlet spigot, securing it to the
underside of the work surface. This will
prevent waste water from the sink running
into the machine.
2. To a stand pipe provided with venthole,
minimum internal diameter 4 cm.
The waste connection must be at a height of
between 30 cm (minimum) and 100 cm
(maximum) from the bottom of the
dishwasher.
30