Installation, Removing the unit, Troubleshooting – JVC KD-APD89 User Manual
Page 324: Installation (in-dash mounting)
2
When installing the unit without using the sleeve /
In a Toyota car for example, first remove the car radio and install the unit in its place.
TOYOTA
When using the optional stay /
Note
:
When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws are
used, they could damage the unit.
8 mm
Flat head screws (M5 × 8 mm)
*
3
M5 × 8 mm
*
3
Flat head screws (M5 × 8 mm)
*
3
M5 × 8 mm
*
3
Screw (option)
Stay (option)
Fire wall
Dashboard
Bracket
*
3
*
3
Removing the unit
Before removing the unit, release the rear section.
Insert the two handles, then pull them as
illustrated so that the unit can be removed.
Do the required electrical connections.
*
1
When you stand the unit, be careful not to damage the fuse on the rear.
*
2
Avoid touching the connectors.
*
3
Not supplied for this unit.
Bend the appropriate tabs to hold the
sleeve firmly in place.
INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require information
regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
•
If you are not sure how to install this unit correctly, have it installed by a qualified technician.
JVC
•
Bracket
*
3
*
3
*
1
*
2
*
3
Install the unit at an angle of less than 30˚.
30˚
TROUBLESHOOTING
•
The fuse blows.
*
Are the red and black leads connected correctly?
•
Power cannot be turned on.
*
Is the yellow lead connected?
•
No sound from the speakers.
*
Is the speaker output lead short-circuited?
•
Sound is distorted.
*
Is the speaker output lead grounded?
*
Are the “–” terminals of L and R speakers grounded in common?
•
Noise interfere with sounds.
*
Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?
•
This unit becomes hot.
*
Is the speaker output lead grounded?
*
Are the “–” terminals of L and R speakers grounded in common?
•
This unit does not work at all.
*
Have you reset your unit?
•
*
•
*
•
*
•
*
*
L
R
–
•
*
•
*
*
L
R
–
•
*
Install1-2_KD-G845_009A_1.indd 2
Install1-2_KD-G845_009A_1.indd 2
2007.12.10 10:00:59 AM
2007.12.10 10:00:59 AM