JVC HR-DVS3EU - Manual (Page 30)

Filename [DVS3EU_1a-EN.fm]
Masterpage:Left
30
EN
Page 30 October 8, 2001 2:37 pm
PLAYBACK/RECORDING ON DV DECK
Basic Playback
(DV deck)
A
Load a cassette.
Make sure the window side is up, the rear label side is
facing you and the arrow on the front of the cassette is
pointed toward the recorder.
● Do not apply too much pressure when inserting.
● The recorder’s power comes on automatically.
● If the erase protection switch is set to “SAVE”, playback begins
automatically. It takes about 15 seconds until the playback
picture appears.
● Make sure the VCR indicator appears on the front display
panel. If not, press TV/VCR on the remote control to turn on
the VCR indicator.
B
Select the DV deck.
Press DV.
● The DV button lights on the recorder.
C
Find the programme start point.
If the tape is advanced past the start point, press 3 or
turn the JOG dial to the left. To go forward, press 5 or
turn the JOG dial to the right.
D
Start playback.
Press 4 .
● The DV playback indicator lights on the recorder.
E
Stop playback.
Press 8 . Then press to remove the cassette.
● The DV playback indicator turns off.
Turn on the TV and select the AV mode.
1 3 2
1 2 3
4 5 6
7 8 9
1
2
1
2
3
0
3
4
4
Usable cassettes
Only cassettes marked can be used with the DV
deck.
DVS3EU_1a-EN.fm Page 30 Monday, October 8, 2001 2:44 PM