JVC LST0728-001C - Manual (Page 105)

97
Input/Output Terminal on Rear Panel
● The audio input acts as a network device in the VR-N1600U/E
system, and the device name assigned to it is ANVRB. The input/
output terminals on the rear panel have been assigned to the
ANVRB device by default. (VR-N1600U/E)
● In VR-N900U, analog input circuitry is considered as a network
encoder (IP video server), and the device name assigned to it is
AN900B. The input/output terminals on the rear panel have been
assigned to the AN900B device by default. (VR-N900U)
Ⅵ Rear Panel Input Terminals
Ⅵ Output Terminals
Note :
● Although the duration of output for the rear panel output
terminals is indicated as0 seconds, it is infinitely output.
● Output events of the rear output terminals cannot be deleted.
● All terminal inputs are treated as alerts, but there can only be
association (sequence) between one terminal with recording
start.
Specifying a VMD Event
1
Select the camera for specifying the VMD event
from the [Defined events] list on the [I/O Setup]
screen
2
Click the [Add VMD Event(Motion Detection)]
button
If a multi-camera device is selected, such as a network encoder (IP
video server), a dialog for you to select the required camera will
appear.
Note :
● The [Add VMD Event(Motion Detection)] button is disabled if
there is no VMD event available for the network camera.
Specifying Timer Events
You can add a timer event to an added event.
A timer event is defined with respect to an input event and is
triggered by that event. Timer events are triggered when the
specified time interval has lapsed after occurrence of the input
event at the preset destination.
1
Select the event for adding a timer event from
the [Defined events] list on the [I/O Setup]
screen
(An example of adding a timer event to the input
event)
2
Click the [Add new event...] button
● The [New Timer] screen appears.
3
Specify the timer interval and timer event name.
Rear Panel Input
Terminal Name
Name of Input Event Event Description
ALARM IN 1 to 8
(VR-N1600U/E)
ALARM IN 1 to 4
(VR-N900U)
Alarm IN 1 to 8 Falling
(VR-N1600U/E)
Alarm IN 1 to 4 Falling
(VR-N900U) Event during
detection of Make
signal input
Alarm IN 1 to 8 Rising
(VR-N1600U/E)
Alarm IN 1 to 4 Rising
(VR-N900U) Even during
detection of Break
signal input
Rear Panel Output
Terminal Name
Name of Output Event Output Action
OPTION OUT1,2
Set output Option Out 1,2
high Outputs the Make
status
Set output Option Out 1,2
low Outputs the
Break status
Item Description
A Timer
event is
started
by: Displays the event or event button name for
which a timer event is added. (This is a read-
only field.)
B Timer
event
name For specifying a name for the timer event.
C Timer
event
occurs
after: For specifying the time interval from the
occurrence of the event or clicking of the event
button until the timer event is triggered. Specify
the time interval in seconds or minutes.
[I/O Setup] Screen
A
B
C
[New Timer] Screen