JVC LST0728-001C - Manual (Page 145)

137
4
Switch on the power of this unit
● If recording is in progress, a [New HDD was found. Are
you OK to stop recording and format new HDD?]
confirmation message appears.
● Upon clicking [OK], a multipartition confirmation screen
appears. (Only when the VR-D series is used)
● Click [OK] to start multipartition. The HDD Utility starts up
automatically. (A Page 116)
Memo :
● External hard disk drives can be used without multipartition.
However, if any one of the hard disks in VR-D breaks down, all
data in VR-D will be corrupted.
● Use each of the “unformat disk” in HDD Utility to perform
initialization.
● The confirmation message will only appear during
recording.
5
Check the entry in the [Volume] field, and click
the [Initialize] button
● The external hard disk drive is initialized.
● Check to ensure that the [Volume] field is set to [unformat
disk], [unpartition disk] and [unknown partition]. Selecting
any other volume may result in the deletion of recorded
data.
Note :
● Consult your nearest JVC dealer or service center for details on
the type of external hard disk drive that can be used.
● When an additional hard disk is connected, several seconds of
the recorded image may be lost during archiving.
● Note that playing back video recorded in an external HDD
simultaneously on this unit and multiple clients may cause delay
in the playback of video images and audio sound.
This is not a malfunction and there is no problem with the
recorded images. Normal playback will be restored when
simultaneous playback stops or when the number of devices
playing back at the same time decreases.
Memo :
● It is recommended that a UPS be used to ensure stable
operation of the system.
● You are unable to view recorded images on the computer by
disconnecting the external hard disk from this unit and
connecting it to the computer.
NAS
NAS is a dedicated file server that is connected to the network.
In the case of NVR, you can specify NAS as a drive for archiving
data.
Memo :
● For details on the settings of this unit when using NAS, refer to
[Archiving] (A Page 108) and [HDD Utility] (A Page 116).
● Follow the NAS [Instruction Manual] for settings on NAS. This
may take a while depending on the format and RAID settings.
For further details, please contact the NAS manufacturer.