JVC AV-32R370KE - Manual (Page 64)

Using the TV’s menu
19
(1*/,6+
$9763(  /&7$8  (QJOLVK
PICTURE FEATURES
„ AUTO VNR
VNR Stands for “video noise reduction”.
AUTO:
This mode reduces any “noise” (interference
or snowing) in the current picture. The
function also adjusts the optimum sharpness
of the picture (SHARP).
MIN:
The AUTO VNR function is cancelled. If
you set the mode to AUTO but feel that the
sharpness of the original picture has not been
reproduced fully, change the mode to MIN.
However, any noise remaining in the original
picture may be emphasized.
MAX:
This mode always reduces any noise as much
as possible, irrespective of state of the
picture. When you set the mode to AUTO but
still notice some noise, change the mode to
MAX. However, this may reduce the
sharpness of the picture.
„ COLOUR SYSTEM
The colour system is chosen automatically.
However, if the picture is not clear or no
colour appears, choose the colour system
manually.
1 Choose COLOUR SYSTEM then
press the a a a a button
2 Press the 5 5 5 5 buttons to chose the
appropriate colour system.
Then press the a a a a button
PAL:
PAL system
SECAM:
SECAM system
NTSC 3.58:
NTSC 3.58 MHz system
NTSC 4.43:
NTSC 4.43 MHz system
AUTO:
This function detects a colour system from
the input signal. Only when you are viewing
a picture from Programme number PR 0
(AV), or EXT terminal, you can choose using
the AUTO function.
• The AUTO function may not function
properly if you have poor signal quality.
If the picture is abnormal in the AUTO
function, choose another colour system
manually.
• When in the Programme numbers PR 0
(AV) to PR 99, you cannot choose NTSC
3.58 or NTSC 4.43.
AV-32&28T35SPE_Eng.fm Page 19 Thursday, February 6, 2003 2:29 PM