Jeep 75598 - Manual (Page 14)

Assembly
12
Steering
Wheel
Steering
Wheel Cover
Tab
Tab
Sound Box
Compartment
Sound Box
• Place the sound box, speaker side down, into the center
of the steering wheel.
• Fit the tab at the top of the steering wheel cover under
the top edge of sound box compartment.
• Fit the steering wheel cover over the sound box buttons
and press near the bottom of the steering wheel cover to
snap it into the steering wheel.
Hint: When it’s time to change the batteries in the sound
box, use a slotted screwdriver to press the bottom tab in
and lift the steering wheel cover.
14
11
Steering
Wheel
Cap Nut
Assembly Tool
Steering
Column
“UP”
Cap Nut
• Turn the vehicle body upright.
• Position the steering wheel upright (see inset).
• Fit the steering wheel onto the steering column.
• Fit a cap nut into the cupped end of the cap nut
assembly tool.
• Hold the cap nut against the end of the steering column.
Tap the cap nut assembly tool with a hammer to secure
the cap nut on the steering column.
Hint: You may want the help of another person to
support the steering column while you tap the cap nut
assembly tool with the hammer.
• Discard the cap nut assembly.
9
10
• Wipe the steering column with a paper towel to remove
any excess lubricant.
• Turn the vehicle body on its side.
• Insert the straight end of the steering column up through
the two holes in the vehicle body and out through the
hole in the dash.
Steering
Column
Holes
Bottom View
• Insert the end of the steering column through the hole in
the steering rod.
• Fit a cap nut into the cupped end of the cap nut
assembly tool.
• While supporting the steering column, hold the cap nut
against the end of the steering column. Tap the cap nut
assembly tool with a hammer to secure the cap nut on
the steering column.
Hint: You may want the help of another person to support
the steering column while you tap the cap nut assembly
tool with the hammer.
Steering Rod
Cap Nut
Cap Nut
Assembly
Tool
End of Steering Column
Bottom View