Jeep 75598 - Manual (Page 21)

21
38
Assembly
37
• Lift the rear of the vehicle.
• Align the holes in the bumper tabs with the screw pegs on
the underside of the vehicle body.
• Insert two #8 x 1" screws through the bumper tabs and
into the vehicle body.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
• Lower the rear of the vehicle.
Gas Cap
Tether
Bumper Tabs Bumper
• Position the gas cap so that its tether points down.
• Insert and “snap” the gas cap into the opening on the
rear bumper.