Jeep 75598 - Manual (Page 23)

Battery Installation
H
IMPORTANT! Use only a Power Wheels ® 12 volt battery.
Use of any other battery will damage your vehicle. Make
sure that you charge the battery for at least 18 hours using
the enclosed Power Wheels
® 12 volt charger before
operating your vehicle for the first time. Charge the battery
for at least 14 hours after each use of the vehicle. Never
charge the battery longer than 30 hours. Failure to follow
these instructions may damage your battery and will void
your warranty. It is easier to install the battery before
assembling the hood to your vehicle. If you have already
assembled the hood to your vehicle, you may want to
remove it to install the battery.
1
• Lift the hood to access the battery compartment.
Battery
Compartment
Hood
23
• Press the battery clamp to slide it into the dash .
• While holding the battery clamp against the dash, place
the battery in the battery compartment . Make sure the
battery is upright and positioned between the locator ribs
at the bottom of the battery compartment.
Pb
Battery
Compartment
Battery
Clamp
Locator
Ribs
2
2
1
Pb
Battery
Compartment
Battery
3
Battery
Clamp
• Release the battery clamp. Make sure the battery clamp
slides over the top of the battery. If the battery clamp
does not slide over the top of the battery, reposition the
battery in the battery compartment. (See step 2.)
4
Pb
Battery
Motor
Harness
Connector
• Plug the motor harness connector into the battery.
Push firmly to make sure the connectors are
completely joined.
Note: To remove a battery from the battery compartment,
disconnect the motor harness connector from the battery.
Press and hold the battery clamp against the dash and
lift the battery from the battery compartment.