Jeep 75598 - Manual (Page 16)

Assembly
16
20
Windshield Frame -
Front
Hinge Pins
Windshield
Bracket
• Rotate the front half windshield frame down so it lays flat
on the vehicle body.
• Working from the center of the vehicle, insert a hinge pin
through the holes in the front windshield frame and the
holes in each windshield bracket, as shown.
• Align the slots in the front half of the windshield frame
with the tabs on the windshield brackets.
• Fit the front half of the windshield frame onto the
windshield brackets as shown.
Slots
Windshield Frame - Front
Tabs
19
• Insert a hood latch into one of the holes in the vehicle
body, near the hood area.
• Twist the base of the hood latch 1 /
4
turn to secure it in the
vehicle body.
• Repeat this procedure on the other side of the hood area
to attach the other hood latch to the vehicle body.
Hood Latch
Hole
17
• Fit the screw pegs on the windshield brackets into the
holes in the top surface of the dash. Press firmly to fit the
lip on each windshield bracket into the slot in the top of
the dash.
• Insert two #8 x 1" screws through each windshield
bracket and into the dash.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Windshield
Brackets
18
Lip of
Bracket
Slot
Hood
Latch
Tabs
Hole