Jeep 75598 - Manual (Page 18)

28
• Extend the canopy completely around the sport bar.
Sport Bar
Canopy
Assembly
18
27
Sport Bar
Canopy
Canopy Sleeves
Canopy
Sleeves
• Position the sport bar on its side so that the sport bar
ends curve away from you.
• Position the canopy opposite the sport bar with the
netting facing away from you.
• Slide the four canopy sleeves onto the sport bar.
25
• With the seat at an angle, insert the tabs on the front
edge of the seat into the slots in the foot-well wall .
• Push down firmly on the edge of the seat above each
tab to insert and “snap” the tabs into the slots .
• Rotate the back of the seat down to insert and “snap”
the seat back tabs into the slots in the vehicle body. Push
down firmly on the seat back.
Seat
Tabs
Slot 1
2
PUSH
HERE
26
• Insert a #8 x 1" screw through the hole in the rear of seat
and into the vehicle body, as shown.
• Tighten the screw with a Phillips screwdriver.
Do not over-tighten.
Seat Back Tab
Tabs
1