JVC OUTDOOR PTZ IP DOME CAMERA VN-V686WPU - Manual (Page 18)

18
Connection/Installation
Mounting the Camera
1
Mounting the fall prevention wire
● Mount the fall prevention wire of the camera to
the fall prevention wire anchor bolt that was
installed earlier.
● Secure the fall prevention wire tightly with a nut
and washer.
2
Pull out the cables (from the wall)
from the cable connection hole.
3
Mount the camera to the wall
● Mount the camera to the camera anchor bolts
that were installed earlier.
● Secure the camera tightly with a nut and
washer.
Note：
● This product weighs approximately 5.5 kg.
When installing, pay extra attention to the fall.
● For your safety, hold the arm section during
installation.
● After installing, paint the nuts and washers to
prevent corrosion.
Memo :
● To remove the camera, follow the reverse
procedures.
Cable Connection
1
LAN Cable Connection (A Page 22)
A Use the provided RJ-45 conversion connector
and connect the LAN cable.
B Wind the connector section with waterproof
tape (adhesive) and push the cable into the
arm of the camera.
2
Connecting the power cable
(A Page 20)
Connect the power cable and wind the
waterproof tape (adhesive).
After connecting, push the cable into the arm of
the camera.
Mounting the Camera
(continued)
1
2
3
Fall Prevention
Wire
Washer
Nut
B
A
Wind the
waterproof tape
(adhesive)
Arm
RJ-45
conversion
connector
(provided)
Wind the waterproof tape (adhesive)
Arm
VN-V686WPU_EN.book Page 18 Tuesday, December 25, 2007 11:23 AM