JVC OUTDOOR PTZ IP DOME CAMERA VN-V686WPU - Manual (Page 22)

22
Connection/Installation
Connect the camera to a hub or computer using
a LAN cable.
ⅷ When connecting to a hub
Make use of a straight cable.
ⅷ When connecting to a computer
Make use of a cross cable.
Note：
● However, cross cables cannot be used with
some computer models. When connecting VN-
V686WPU directly to a computer, check the
computer’s LAN specifications in advance.
Connect the alarm signal cable to external
devices, such as a sensor or buzzer.
Note：
● Noises from an external source may cause the
camera to malfunction even when the cable
used is within 50 m. In this case, move the cable
away from the noise source.
LAN Cable Connection
Cable to use
● Shield (STP) cable
● Make use of a Category 5 (or higher) cable
when 100BASE-TX is used.
RJ-45
conversion
connector
(provided)
Connecting the alarm signal
cable
Cable to use
● Length of 50 m or shorter
● UL1007, UL1015 or equivalent products
● AWG#22 to AWG#18 or equivalent products
Solder welding or
crimping
Insulating
tape
VN-V686WPU_EN.book Page 22 Tuesday, December 25, 2007 11:23 AM