JVC OUTDOOR PTZ IP DOME CAMERA VN-V686WPU - Manual (Page 34)

34
Settings and operation of the built-in viewer
Internet Explorer Setup (continued)
3
If ActiveX controls and plug-ins of the Internet Explorer is disabled, follow the steps
below to enable it
● Click [Trusted sites] under [Tool]-[Internet Options]-[Security]. Upon doing so, the [Sites…]
button directly below becomes active. Click this button and deselect the check [in the displayed
window]. Next, add the IP address of VN-V686WPU. If the setting is factory default, add the
following web site to the zone.
http://192.168.0.2
● Click [Trusted sites] under [Tool]-[Internet Options]-[Security]. Select the [Custom Level] button
and open the [Security Settings] window. Set all items under [ActiveX controls and plug-ins] in
the opened window to [Enable]. Enable also [Use the following IP address] under
[Miscellaneous].
4
If the pop-up block function of the Internet Explorer is enabled, follow the steps
below to disable it
T The built-in viewer cannot be used when the pop-up block function is AenabledB.
● Selecting [Tool]-[Pop-up Blocker]-[Turn Off Pop-up Blocker] permits all sites.
● To permit only specific sites for VN-V686WPU, select [Tool]-[Pop-up Blocker]-
[Turn On Pop-up Blocker]. Select the selectable [Tool]-[Pop-up Blocker]-[Pop-up Blocker
Settings] and open the [Pop-up Blocker Settings] window. In the opened window, add the
address of VN-V686WPU as a permitted web site address.
5
When plug-in tools such as the Yahoo or Google toolbar are included in the Internet
Explorer, disable the pop-up block function of these plug-in tools as well
Memo :
● To use the built-in MPEG4 Viewer of VN-V686WPU, install “ffdshow” that is open source codec. You can
download “ffdshow” from the Internet.
Preparation (continued)
VN-V686WPU_EN.book Page 34 Tuesday, December 25, 2007 11:23 AM