JVC OUTDOOR PTZ IP DOME CAMERA VN-V686WPU - Manual (Page 30)

30
Network Settings
ⅷ Changing the IP address using the Internet Explorer (continued)
6
The top page of VN-V686WPU appears
7
The [Basic] page with the IP address settings appears
A confirmation screen appears. Press the [OK] button. VN-V686WPU restarts using the new IP
address. It takes about one minute for the camera to reboot.
Memo :
● Access from this computer may fail when the IP address of VN-V686WPU is changed. To enable access
to VN-V686WPU from the same computer, alter the IP address at the computer accordingly.
IP Address Settings
(continued)
Click on [Network], followed by [Basic] on
the next submenu.
A
B
C
Enter the values you wish to specify in the
[IP Address], [Subnet Mask] and [Default
Gateway] fields.
Click [OK].
Set the [IP Setting] item to [DHCP
Disable].
When the display or configuration of the opened screen appears strange, check the computer
settings using the following procedures.
A Click [Start]-[Control Panel]-[Display] and open the [Display Properties] window
B Click the [Settings] tab in the [Display Properties] window and click the [Advanced] button
C Check that [DPI setting] in the [General] tab has become [Normal size(96DPI)]
D Otherwise, change the setting to [Normal size(96DPI)] and reboot Windows
VN-V686WPU_EN.book Page 30 Tuesday, December 25, 2007 11:23 AM