Jensen Tools 100 Sereis - Manual (Page 33)

BudgeTone-100 User Manual
Grandstream Networks, Inc.
- 33 -
Use DNS SRV Default is No.
If set to Yes, the phone will use DNS SRV configured to lookup for the server
Use ID is phone
number If “Yes” is set, a “user=phone” parameter will be attached to the
“From” header in SIP request, which will be processed by supported SIP proxy.
Default is No.
SIP registration This parameter controls whether the BudgeTone phone needs to send
REGISTER messages to the proxy server.
The default setting is “Yes”.
Unregister On
Reboot Default is No. If set to Yes, the phone will send “remove all register” request to
the server (“*” in the contact header) to remove all previous bindings. If server
does not support this it will cause some problems
Register
Expiration This parameter allows the user to specify the time frequency (in seconds) the IP
phone will refresh its registration with the specified registrar (SIP Server). The
default interval is 3600 seconds (or 1 hour). The maximum interval is 45 days.
Early Dial Default setting is No. The “Yes” option should be used ONLY if there is a SIP
proxy configured and the proxy server supports 484 Incomplete Address
response (like Asterisk). Otherwise, the call will most likely be rejected by the
proxy (with a 404 Not Found error).
Please note that this feature is NOT designed to work with and should NOT be
enabled for direct IP-to-IP calling.
Allow outgoing
call without
Registration Default is No. If set to Yes, if ITSP permit, phone can make outgoing call even
not registered. But can not get incoming calls. This feature is highly depended
on ITSPs.
Dial Plan Prefix Sets the prefix added to each dialed number. If configured, the prefix will be
added to EVERY number input
No key Entry
Timeout Default is 4 seconds.
User can short or extend that depends on digits dialed habit
Use # as
Dial Key This parameter allows the user to configure the “#” key to be used as the
“SEND” key. Once set to “Yes”, pressing this key will immediately trigger the
sending of dialed string collected so far. In this case, this “#” key is essentially
equivalent to the “SEND” key.
If set to “No”, this # key will then be included as part of the dial string to be sent
out.
Local SIP port This parameter defines the local SIP port the IP phone will listen and transmit
on. The default value is 5060.