Jensen Tools 100 Sereis User Manual
Page 35
BudgeTone-100 User Manual
Grandstream Networks, Inc.
- 35 -
Send DTMF
This parameter specifies the mechanism to transmit DTMF digits.
There are 3 modes supported: in audio, which means DTMF is combined in in-
band audio signal (not very reliable with low-bit-rate codec); via RTP
(RFC2833); or via SIP INFO.
Make sure this setting is synchronized with SIP server otherwise will not work.
DTMF Payload
Type
This parameter sets the payload type for DTMF using RFC2833
Default is 101
Send Flash Event Default is NO. If set to Yes, flash will be sent as DTMF event therefore the
FLASH key to switch calls will NOT work.
Onhook
Threshold
Time period when cradle pressed (Hook Flash) to simulate FLASH. Adjust this
time value will prevent user on hook carelessly to activate Flash/Hold and cause
the phone ring back. Default is 800ms.
NTP server
URI or IP address of the NTP (Network Time Protocol) server, which will be
used by the phone to synchronize the date and time.
Default Ring
Tone
• By default “System Ring Tone” is selected. All calls received that do not
match any “incoming caller ID” number will generate the selected ring tone
- system, 1, 2 or 3.
• The user can setup up one number on each of the ring tones 1, 2, and 3.
When a call is received from one of these numbers, the respective ring tone
will be generated.
• If the ring tone does not exist, the system default ring tone will be played.
For BT-100, ring 3 is not supported.
Send Anonymous
If this parameter is set to “Yes”, user ID will be sent as anonymous, essentially
block the Caller ID from displaying.
Anonymous
Method
This is decided by supported SIP server/proxy. Either “Use From Header” or
“Use Privacy Header” depends on how SIP sever/proxy process the SIP header.
Time to ring
Allow user to adjust the ring time of the phone. Default is 60 seconds
Special Feature
Default is Standard. Choose the selection to meet some special requirements
from Soft Switch vendors like Nortel, Sonus, Broadsoft, etc. End user please do
not touch this parameter.
Syslog Server
The IP address or URL of System log server, especially useful for ITSP (Internet
Telephone Service Provider). End user don’t encourage to touch this part