Pin assignment, 12-pin multi-connector (dc-in/trigg, Digital output connector for giga – JAI AT-140GE User Manual
Page 12: At-140ge
AT-140GE
- 10 -
5. Pin Assignment
5.1. 12-pin Multi-connector (DC-IN/Trigger)
Type: HR10A-10R-12PB-01
(Hirose) male.
(Seen from rear of
camera.)
Fig. 3. 12-pin connector.
*1) 75 ohm termination can be selected by DIP SW600.
5.2. Digital Output Connector for Gigabit Ethernet
Type: RJ-45
HFJ11-1G02E-L21RL or equivalent
The AT-140GE cameras also accept industrial RJ-45 connectors with
thumbscrews. This assures that the connector does not come undone
in tough industrial environments.
Please contact the nearest JAI distributor for details on
recommended industrial RJ-45 connectors.
Fig. 4. Gigabit Ethernet connector
The digital output signals follow the Gigabit Ethernet interface using RJ-45 conforming
connector. The following is the pin assignment for the Gigabit Ethernet connector.
Pin No
In/Out
Name
1
In/Out
MX1+ (DA+)
2
In/Out
MX1- (DA-)
3
In/Out
MX2+ (DB+)
4
In/Out
MX3+ (DC+)
5
In/Out
MX3- (DC-)
6
In/Out
MX2- (DB-)
7
In/Out
MX4+ (DD+)
8
In/Out
MX4- (DD-)
Pin no.
Signal
Remarks
1
GND
2
+12 V DC input
3
GND
4
Iris video
Continuous and RCT modes only
5
GND
6
-
7
-
8
GND
9
XEEN out
Negative logic
10
Trigger in
*1)
11
-
12
GND
3
4
5
6
7
8
9
10
11
12
1
2