JVC DynaPix LT-32DX7SSP - Manual (Page 9)

13 14
ENGLISH
CH 28
>> Auto Program
14%
01 AV PR
02 03
04
05 06
07
08 09
ID CH/CC
TVE1 CH 21 CH 22 CH 23
CH 24
CH 25 CC 02
CC
CC 04 CC 05
03
> Edit
Download TV Recording Device
T-V LINK
> Language
>
United Kingdom
Country
Deutschland France Italia España Nederland Belgium
Ireland
Switzerland
Danmark Sverige Österreich Norge Suomi
Auto Program
IMPORT
ANT!
PREP
ARE
USE
SETTINGS
TROUBLE?
Initial settings
(continued)
4 Set analogue channels
Initial setting is complete
 Edit digital channels  Editing digital channels (P. 47)
 If digital channel reception is poor  When the digital channel reception is poor (P. 14)
 If analogue channel reception is poor  Troubleshooting (P. 51)
 Some digital channels cannot be watched on this TV.  (P.57)
5
Register analogue channels
 If “ACI Start” appears, select and start settings.
(This will set up cable television channels.)
 “What is “ACI” (Automatic Channel
Installation)?” (P. 56)
Check what was registered
 Edit analogue channels
 @ in “Editing analogue
channels” (P. 49)
 When not using
T-V LINK
 When using T-V LINK
 If “Feature Not
Available” appears :
 Is a T-V LINK compatible
device connected to EXT-2?
 Is the device turned on?
Set TV-LINK
 Confirm
Confirm the language
select
3
 When not using analogue channels  
 When using analogue channels (or cable TV) 
 When change a language

1
2
3
select
 When change a country
When the TV cannot find the digital channels
 Is the TV connected correctly to the aerial?
 Change the direction of the indoor aerial.
 Is there a digital channels transmission tower nearby?
 Turn “Attenuator” to “On” (P. 36), since the radio waves are too strong.
Check the following points
 Register digital channels again  “Service Scan” (P. 45)
 If you still cannot watch digital channels after following the steps above, there may be a problem
with your aerial or its cable. Or, the signal may be too weak.  Consult your retailer
When the digital channel reception is poor
The “Missing or weak signal” message appears.
 Check digital channels signal  Signal Check (P. 45)
 If you still cannot watch digital channels after following the steps above, there may be a problem
with your aerial or its cable. Or, the signal may be too weak.  Consult your retailer
 Is the TV connected correctly to the aerial?
 Change the direction of the indoor aerial.
 Is there a digital channels transmission tower nearby?
 Turn “Attenuator” to “On” (P. 36), since the radio waves are too strong.
Check the following points
 Language for on-screen analogue
channel displays and menus
(excluding the DTV menu)
@
⁄
13-14 6/29/2006 1:12:58 PM