Jabra GO 6470 - Manual (Page 14)

14
en
g
li
sh
Jabra GO 6470 User manUal
4.2 Quick-StaRt SetuP wizaRd
to get started, just power the Jabra GO base and then follow the set-up-wizard instructions on the touchscreen.
to run the setup wizard:
1. review the information outlined in Section 4.1: Setup overview and Background. It will help you understand the
types of tasks that the setup wizard will ask you to do.
2. assemble the Jabra GO base and apply power to it. (see also Section 4.3: Assembling the Jabra Go Base and
headset).
3. the Jabra GO base automatically launches the setup wizard the first time you turn it on. On each page of
the wizard, follow the instructions shown and then touch the “next” icon (see also Section 8.2: using the
touchscreen).
- Note: when the wizard is helping you set up your desk phone, it will ask you to call the Jabra test server.
this enables the Jabra GO base to test its clear dial-tone switch and mic-level settings by exchanging
signals with the test server. see your Jabra GO Quick start Guide for a list of Jabra test-server phone
numbers (also available on our web site). If, for some reason, the connection to the test server fails, you are
prompted to retry; you can retry the automatic setup or try a manual setup. you can also choose to retry
the cable setup.
4. Continue until the wizard tells you that you are finished. at this point, all of your phones should be connected
and your headset will be fully configured to work with each of them.
the remainder of this chapter provides extra information about each step of the setup process. refer to this
chapter if you have trouble while working through the on-screen setup wizard.
Tip: you can re-start the setup wizard manually at any time, thereby re-initializing some or all base and
headset settings. see the section “Advanced Settings menu” for more.
4.3 aSSeMBling the Jabra go BaSe and headSet
Apply Power to the Jabra GO Base
Connect the power adapter to the port marked
on the Jabra GO base, and then plug the power adapter into
a wall outlet as shown in the figure below.
Figure 6: Powering the Jabra Go base