Jabra GO 6470 - Manual (Page 54)

54
en
g
li
sh
Jabra GO 6470 User manUal
Note: call collision is not the same as call waiting, which is sometimes available when you are talking
on one phone and a call comes in on that same phone. see Section 8.6: Managing Call Waiting for details
about how this is handled.
8.8 Managing call waiting
for a general discussion of call waiting, see the earlier section “Managing Call Collisions and Call Waiting”. this
section deals with handling call waiting on the base touchscreen.
when call waiting is triggered by a new incoming call, the following occurs:
- the standard call-waiting tone will sound in your headset.
- the touchscreen displays the incoming number (if available) and provides controls for handling the new call,
as shown in the figure below.
- Call-waiting control is enabled for the headset multifunction button. the commands for this are also
mentioned in the figure below.
Figure 58:
4 5
1
2
3
1. Current phone: the phone on which you are talking.
2. Caller ID: the incoming call number is shown here, if available.
3. Ringing phone: the phone on which the incoming call is arriving.
4. Accept new: touch here — or press the headset multifunction button
— to put your current call on hold and answer the incoming call.
5. Reject new: touch here — or double-tap the headset multifunction
button — to remain on your current call and reject the incoming call.
Note: you can also tap the headset mfB to end the current call and
answer the incoming call.
touchscreen controls for managing call waiting when a new call arrives
If you touch the green handset icon shown in the figure above, you put a call on hold. while you have one — or
more — calls on hold, a plus sign and a shadow are shown on the target phone icon, as shown in the figure
below:
Figure 59:
2
1
1. End and switch: touch here — or tap the headset multifunction button
— to terminate your current call and activate the next held call.
2. Mute: enables you to mute/unmute the microphone on your headset.
you can also do this by double-tapping the touch-panel on the side of
your headset.
3. Phone menu: touch the phone icon to display the phone menu (PC &
Softphone menu, in this case). this allows you to put your call on hold,
on audio-hold or to hold-and-switch calls— see fig. 61 for more.
one or more calls on hold (call waiting)