Jabra GO 6470 - Manual (Page 42)

42
en
g
li
sh
Jabra GO 6470 User manUal
the precise effect of each type of gesture depends on what you are currently doing (e.g., if you are already on a
call, which phone is the current target, etc.). the table below summarizes all of the control possibilities presented
by the multifunction button.
Function Tap
Double-
Tap
Press
(hold 1-3 sec)
Long Press
(hold 3-5 sec)
answer incoming call

Connect to the current target phone
(e.g., go to dial tone; voice-activated dialing)

enable voice-activated dialing (when target is
a cell phone that supports this)

end current call (and activate held or incoming
call, if any)

Call the last number dialed on current target
phone (supported softphones and mobile
phones only)

reject incoming call (when already on a call)

switch target phone (when no call is active) 
power-on headset
(when power is off)

reject incoming call (when no call is active)

hold current call and switch to held or
incoming call (supported softphones and
mobile phones only)

power-off headset
(when power is on)

activate Bluetooth® pairing mode (when power
is off)

table 3: All multifunction button commands
The Touch Panel
the headset features a touch panel that is similar to the touch pad included with many laptop computers. Use it
to adjust the volume you hear in your headset and to mute/unmute the microphone.
- slide your finger up the touch panel (away from your mouth) to increase the volume.
- slide your finger down the touch panel to decrease the volume.
- double-tap on the touch panel to mute or unmute the microphone.
see also Section 6.6: Controlling the Speaker Volume and Microphone.