Jabra GO 6470 - Manual (Page 44)

44
en
g
li
sh
Jabra GO 6470 User manUal
Choosing Voice or Tones for Target indicators
the headset is capable of playing either a tone or a human voice when you change the target phone, thus telling you
what the new target is. the human voice is always in english, regardless of your other language settings. By default, the
human voice will be played. however, if you do not like hearing the english voice, you can switch to using the tones.
to change this setting, use the touchscreen menus (see the section “Settings menu”) or the Jabra Control Center
program of the Jabra pC suite running on your pC.
Headset Visual Indicators (LED)
the headset includes a multicolor led, which indicates the state of the headset as outlined in the table below.
during charging, the headset shows the charging progress in combination with the table’s various visual
indicators as follows:
- less that 10% battery capacity: state led indication (see table below) is shown interspersed with a constant red light
- Between 10% and 100% battery capacity: state led indication is shown interspersed with a constant yellow light
- fully charged: state led indication is shown interspersed with a constant green light
Headset state LED when battery level is good LED when battery level is low
Idle (powered on, but not
connectable, pairing, ringing, call
active or audio link)
Blue 200ms
Off 4800ms
repeats for 60 seconds
same as for good battery level
Connectable
Green 300ms
Off 300ms
Green 300ms
Off 300ms
Green 300ms
Off 1500ms
repeats for 60 seconds red 100ms
Off 500ms
red 100ms
Off 500ms
red 100ms
Off 1700ms
repeats indefinitely
Call active or audio link open
Blue 100ms
Off 300ms
Blue 100ms
Off 2000ms
repeats indefinitely red 100ms
Off 300ms
red 100ms
Off 2000ms
repeats indefinitely
ringing
Blue 100ms
Off 300ms
Blue 100ms
Off 1000ms
repeats indefinitely red 100ms
Off 300ms
red 100ms
Off 1000ms
repeats indefinitely
power being turned on
Green 100ms
Off 100ms
repeats to a total of 3 times
same as for good battery level